Downloadable Installation Guides (PDF):
Wall (191Kb)
Ceiling (64Kb)
Cornice (195Kb)
Wet Area (119Kb)
Cornice Installation:
Shown below are installing instructions for our cornice range.
Step One
Shows the strip which is to be installed first. This can be installed with a small nail, tack or screw, the lip is to face out.
Step Two
Shows the cornice slipping into the strip straight over the top of exiting Gyprock cornice. There is no need to remove old cornice unless the cornice is larger than the cornice which you have purchased.
Step Three
Shows the cornice in place, which you can then affix along the top edge into your ceiling with nails, tacks etc.
Step Four
This picture shows the Sheeting then going over the top edge and butting up ready for affixing in place.
*
Please note in some cases a Batten will be needed to be fitted. Place batten
width from the wall, to the back of the cornice. This is to push cornice
against to prevent any distortion which might occur.
The installation instructions are to be used only with Pressed Tin Panel Products. They are designed by us for our range only.
We take no responsibility for incorrect installation of our products they are to be used as a guide only. If you have any questions please feel
free to
contact us and we will guide you through the process. Alternatively contact the
retail outlet of purchase.
|
